Descargar Imprimir esta página

Parkside PSSA 3.6 C4 Traduccion Del Manual De Instrucciones Originales página 51

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

All manuals and user guides at all-guides.com
Set the direction of rotation
You can select the direction of rotation with
the direction switch (clockwise and anti-
clockwise direction) and secure the device
against accidental start up.
1. Wait for the device to shut-down.
2. Clockwise direction:
Press direction switch (9) to
the right.
3. Anticlockwise direction:
Press direction switch (9) to
the left.
4. Switch lock: Bring direction switch
to neutral position.
Direction switch may only be activat-
ed at a standstill to prevent damage
to the transmission.
Inserting/replacing bits
Prior to commencing any work on the
device, bring the direction switch
(
9) to the neutral position in order
to prevent an accidental start up.
1. Insert the desired bit (14) or bit
holder (15) into the bit adapter
(11). It locks into place audibly.
2. To remove the bit or bit holder
pull the spring sleeve (1) back.
3. With the spring sleeve (1) pulled
back remove the bit or bit holder
from the bit adapter (11). Release
the spring sleeve.
Torque setting
Always turn off the device, before
setting the torque.
1. Turn the adjusting ring (2) to se-
lect the desired torque:
Step 1 -->
Step MAX --> highest torque
Screws:
Drilling:
2. Start with a lower torque step and
increase according to require-
ment.
The necessary torque is dependent on:
-
the type and hardness of the
material to be treated;
-
the type and length of the
screws used.
Handle setting
Prior to commencing any work
on the device, bring the direction
switch (
9) to the neutral position
in order to prevent an accidental
start up.
The device can be locked in two hand set-
tings:
-
Pistol grip position
-
Rod position
Press the release key PRESS (4) and
turn the handle (6) of the device by
180°. It locks into place audibly.
Use as a torch
1. Press the torch lens (5) on the
underside of the handle (6). The
torch LEDs light up.
2. To switch off the LEDs press the
torch lens (5) again.
GB
MT
lowest torque,
(4 Nm).
Steps 1 - 6
Step MAX.
51

Publicidad

loading