Publicidad
Idiomas disponibles
Idiomas disponibles
Programming
Remote Control
Your remote control has been programmed at the factory to operate with your garage door opener. If the remote does not work or you would like to
program additional devices, follow the programming steps below.
Up to 40 Security+ 2.0
remote controls can be programmed to the garage door opener. Older LiftMaster remote controls are NOT compatible.
®
Programming can be done through the door control or the learn button on the garage door opener. To program additional accessories refer to the
instructions provided with the accessory or visit LiftMaster.com. If your vehicle is equipped with a Homelink
depending on the make, model, and year of your vehicle. Visit www.homelink.com for additional information.
To add, reprogram, or change a 893LM remote control/877LM keyless
entry pin using the door control
1.
Press the navigation button below "MENU" to view the Features menu
2.
Use the navigation buttons to scroll to "PROGRAM".
3.
Select "REMOTE" or "KEYPAD" to program from the program menu.
4.
Remote Control: Press the button on the remote control that you wish
to operate your garage door.
5.
Keyless Entry: Enter a 4-digit personal identification number (PIN) of
your choice on the keyless entry keypad. Then press the ENTER
button.
The garage door opener lights will flash (or two clicks will be heard) when
the code has been programmed. Repeat the steps above for programming
additional remote controls or keyless entry devices. If programming is
unsuccessful, program the remote using the learn button.
Program a 893MAX remote control using the learn button on the garage
door opener
1.
Press and hold the program button on the remote control until the
LED on the front of the remote control turns on.
2.
Press and release the remote control button you wish to use and then
press any other button to exit programming.
3.
Press and release the Learn button on the garage door opener. The
Learn LED will light. Within 30 seconds...
4.
Press the remote control button programmed in step 2 until the
garage door opener light flashes or two clicks are heard.
To program other types of remote controls or keyless entries see the
instructions included with the device or visit LiftMaster.com.
Add MyQ serial number to MyQ App
To program the Wi-Fi garage door opener to your network, refer to your
owner's manual.
, you may require an external adapter
®
1.
2.
Press
1.
2.
Visor Clip
4
3.
to continue
Press
to continue
3.
4.
OR
PIN
4.
LEARN
Button
LEARN
LED
Publicidad
