Publicidad
Idiomas disponibles
Idiomas disponibles
3. Installation Procedure
3-1 Determine Where to Install the Wired Controller
Make sure to refer to "1. Safety Precautions" to determine the location.
3-2 Structural Dimensions
20mm
86mm
FOLLOW ME
60mm
RT1
Figure 3.1
Figure 3.2
3-3 Rear Cover Installation
3-3-1 Insert a small slotted-head screwdriver into the bottom slot of the wired controller and
rotate in the direction indicated to remove the rear cover of the wired controller. Pay attention
to the direction of rotation to prevent any damage to the rear cover of the wired controller. (see
Figure 3.3)
Screwdriver rotation direction
Slotted screwdriver
Figure 3.3
4
V.2
Publicidad
