Guide to system configuration for the use of virtual keys
Warning! The following guide only lists the parameters required to configure the user App for receiving a
call from the external entrance panel with virtual keys enabled. Virtual keys allow every user registered
via the Comelit App to generate PINs and QR codes to share with third parties, for access from suitably
configured external entrance panels. All parameters not listed in the following guide are used for advanced
functions which fall outside app configuration with virtual keys enabled; for further information please refer to
the full manual for art. 1456B.
Configuration of art. 1456B
Select product number 1456B and set the following parameters:
1. Select Main settings/App connection settings and in the Virtual Keys section select the virtual keys
share mode you want to use:
• qrcode: the app can be used to generate a QR code only, for sharing with other users to allow them to
access the configured external entrance panel.
• pincode: the app can be used to generate a PIN code only, for sharing with other users to allow them to
access the configured external entrance panel.
• pincode_qrcode: the app can be used to generate a QR code and PIN code, for sharing with other
users to allow them to access the configured external entrance panel.
f When configuration is complete, press Write page to save the configuration.
2. Select Main settings /Apartments
This section should be used to configure the apartment enabled to use the App and the virtual keys
If no apartments are available, make sure you have loaded the license provided properly; if, on the other
hand, an apartment is available, configure it as follows:
• Enabling: Enabled
• License type: Master
• ViP address: 00000001
• Description: Enter a description of your choosing for the apartment (e.g. Apartment 1); this parameter
may be useful if the external unit also incorporates art. UT9270 or art. UT9260M, to view
the description entered directly on the external entrance panel.
• Virtual Key: True
f When configuration is complete, press Write page to save the configuration.
24
1
2
3
4
5