Publicidad
Idiomas disponibles
Idiomas disponibles
Use an earthed socket!
The device may only be operated using a socket with
properly installed fuse protection.
Workplace safety
Ensure that the machine is stable and secure. If possi-
ble, secure the machine to a floor plate or a workbench.
Protection against electric shock!
Protect the device against moisture. The device must
not be moist nor operated in a moist environment.
Check the device and the mains connection cable
with plug prior to each use. Avoid physical contact with
earthed parts such as pipes, radiators, etc.
Protect against fire or explosion!
There are sparking components inside the device. Do
not use the device in the vicinity of combustible fluids or
gases. There is a risk of fire or explosion if disregarded.
6. Residual risks
The power tool is state-of-the-art and has been
built according to the recognised technical safety
regulations. However, individual residual risks can
arise during operation.
• Danger to health due to the rotating tool if hair is long
and clothing loose. Wear personal protective equip-
ment such as a hair net and close-fitting clothing.
• Risk to health due to flying chips. Wear personal pro-
tective equipment such as eye protection.
• Injuries due to the workpiece being ejected at high
speed due to improper holding or guiding, such as
working without the vice or stop.
• Health hazard due to electrical power, with the use
of improper electrical connection cables.
• Furthermore, despite all precautions having been
met, some non-obvious residual risks may still re-
main.
• Residual risks can be minimised if the "safety in-
structions" and the "Proper use" are observed along
with the whole of the operating instructions.
• Avoid accidental starting of the machine: the oper-
ating button may not be pressed when inserting the
plug in an outlet.
• Use the tool that is recommended in this manual.
This is how to ensure that your drill provides opti-
mum performance.
• Keep your hands away from the working area when
the machine is in operation.
• Before performing setting or maintenance work,
switch the device off and unplug the mains plug.
7.
Technical data
Length x width x height
Table size
Table pivot range
Table turning range
Gap between chuck
and table
Gap between chuck
and floor plate
Column ø
Chuck adapter
Drill chucking range
Maximum drilling depth
Speed levels
Engine
Engine output
Operating mode
Cable length
Weight
Technical changes reserved!
Noise data
The noise and vibration levels have been deter-
mined in accordance with EN 3746.
The stipulated values are emission values and so do
not necessarily represent safe working values. Al-
though there is a correlation between emission levels
and exposure levels, it is not possible to reliably deter-
mine whether additional precautionary measures will
be required or not based on this. Factors that could in-
fluence the exposure level present at any given time in
the work area include the duration of exposure, the na-
ture of the working area, other noise sources etc. e.g.
the number of machines and neighbouring processes.
The permissible working values can also vary from
country to country.
However, this information should enable the operator
to better evaluate the hazards and risks.
www.scheppach.com
235 x 482 x 732 mm
194 x 165 mm
-45 ° / 0 ° / 45 °
360 °
305 mm
405 mm
48 mm
B16
3 - 16 mm
50 mm
510 - 800 - 1300 - 1800 -
2430 rpm
230V / 50Hz
550 W
S2 10min
1830 mm
23 kg
GB | 31
Publicidad
