Zizito REGINA Manual De Instrucciones página 14

1. Losing the shoulder straps
EN
2. Securing the baby with the harness
Firstly, adjust the shoulder straps height (see point ADJUSTING THE SHOUL-
DER HEIGHT), proceed as follows:
Step 1.Loosen the harness (see point above), open the buckle, and place them
down sideways. Seat your child in the child car seat. Place both shoulder straps
over your child's shoulders.
Step 2. Put the two metal sections of the buckle connectors together(fig. 1), Slot
the two buckle connectors into the slot in the top of the buckle until they "click"
into place (fig. 2 ) Check if the harness is correctly locked by pulling the shoulder
straps upwards(fig. 3 ).
3. Tighten the shoulder harness
14
Step 1: The shoulder straps are slackened by pressing the
lever (under the seat cover) on the front of the seat.
Step 2: Press down on the label marked "Press" as you grip
the two shoulder straps with your other hand. Pull the shoul-
der straps towards you to loosen it.
1.
Pull the shoulder straps upwards to remove the whole
harness then pull the adjuster strap until the harness is fully
tightened (fig. left).
The harness should be adjusted as tightly as possible with-
out causing discomfort to your child.
To release the harness (see point ADJUSTING THE SHOUL-
DER HEIGHT), press the red button on the buckle down-
wards.
2. 3.