EN
EN
•
If there is a interference between the adult safety-belt buckle and
child restraint. You shall be advised to contact the child restraint
manufacturer if in doubt about this point.
•
Do not use any load bearing contact points other than those de-
scribed in the instructions and marked in the child restraint.
•
When you use this child restraint system at Gr.I, and fix the seat by
ISOFIX must read the car manufacturer's handbook.
•
WARNING: Air bags can cause injury. Do not use this child seat on
a passenger seat fitted with an active frontal air bag installed.
4.ADJUSTMENTS
4.1 Remove the seat cushion. the Cs128 must be
used for children from 0 to 10 kg (approximately
new born to 10 months old) with the seat cushion
(Fig.1)
Once your child's weight is between 10 kg to 13 kg
(the approximately 10months to approximately 15
months) you must remove it as below:
Press on the release button ( part no.23 page 01)
and separate the buckle tongue(part no. 24), Then
pull at the edge of the seat cushion to remove
it.(fig.2)
4.2 Adjusting the handle position.
The handle (part no.27) of CS128 child seat can
adjust to different position. Method as below:(fig.3)
4.2.1 Press the handle release button (part no.26
page 01) on the handle at the same time by both
hand.
4.2.2 Now toward the arrow direction push back-
ward and forward can adjust the position.(fig 3)
18