Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING
INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
Intended use:
The machine is intended for sawing wood, plastic,
metal and building materials while resting firmly on the
workpiece. It is suitable for straight and curved cuts with
bevel angles to 45°. The saw blade recommendations are
to be observed.
BEFORE PUTTING INTO OPERATION
CHARGING THE BATTERY PACK (See Fig. A)
NOTE:
a) Do not use any charger other than that
specifically provided for use with the
equipment.
b) If the battery pack is very hot you must
remove your battery pack from the
charger and allow time for the battery to
cool down before recharging.
c) The battery in your new tool is not
charged when it leaves the plant.
Therefore it must be full charged before
using the first time.
d) Please charge the battery to reach full or
no less than half charge before storage. If
the tool will not be used for long periods
of time, charge the battery every 3-6
months.
CHARGING PROCEDURE
1)
Plug the charger into an appropriate outlet. The light
will be green.
2) Slide the battery pack into the charger, the light
will turn to red to indicate the charging process has
started.
3)
When charging is completed, the light will turn to
green. The pack is now fully charged, unplug the
charger and remove the battery pack.
WARNING: When battery charge runs
out after continuous use or exposure
to direct sunlight or heat, allow time for the
battery to cool down before re-charging to
achieve the full charge.
EN
CHARGING INDICATOR
Light
Red on
Green on
OPERATION
1.INSTALLING AND REMOVING THE
BATTERY PACK
a) TO REMOVE THE BATTERY PACK
(See Fig. B1)
Depress the Battery Pack Release Button firmly first and
then slide the Battery Pack out from your tool.
b) TO INSTALL THE BATTERY PACK
(See Fig. B2)
Slide the fully charged Battery Pack onto the tool with
sufficient force until it clicks into position.
2. HAND GRIP AREAS
Always ensure you maintain a firm grip whilst operating
your jigsaw.
3. ALLEN KEY STORAGE(See Fig. C)
The allen key (4) is placed at the position as shown.
4. BLADE FITTING (See Fig. D, E, F)
NOTE: Before any work on the tool itself, remove the
battery. Wear protective gloves when assembling the saw
blade. You can only use the blade type shown in (FIG D).
Don't use other blade types.
INSERTING THE SAW BLADE
To open the Tool-free Blade Holder (10) rotate the ring
anti-clockwise (Jigsaw upside down) and hold in position
(See Fig. E). Then fully insert the blade into the blade
holder slot with blade teeth facing forward and release
the ring, which will self rotate and clamp over the top of
the blade. Push the blade into the blade holder again to
ensure it is locked in position.
Ensure the edge of the blade is located in the groove of
the blade guide (See Fig. F).
REMOVING THE SAW BLADE
To remove a blade, hold the blade and rotate the blade
holder ring anti-clockwise then lift out the blade (blade
could be spring ejected).
Status
Charging
Fully Charged
19
Publicidad
