Publicidad
Idiomas disponibles
Idiomas disponibles
PLEASANT HEARTH GAS FIREPLACE INSERT BLOWER INSTALLATION INSTRUCTIONS
If you are installing the zero clearance blower on models: PHZCI28LP / PHZCI28NG / PHZCI32LP /
PHZCI32NG, please follow the instructions below.
NOTE: The firebox must be connected to a main power supply at the time of the firebox installation. If an elec-
trical connection has not been installed in the firebox, the blower will NOT be able to be installed. Please refer
to your firebox owners manual for more information about the electrical connection.
NOTE: If any of the original wire as supplied with the appliance must be replaced, it must be replaced with a
wire of at least an equal temperature rating.
CAUTION: Label all wires prior to disconnection when servicing controls. Wiring errors can cause
improper and dangerous operation. Verify proper operation after servicing.
NOTE: If an electrical connection has NOT been installed in the firebox, the blower CANNOT be
installed.
1. Remove top grill (if frame is not already removed).
2. Remove bracket from top vent by unscrewing x4
screws. Set these screws aside to use again later.
3. Assemble the zero clearance blower and the
removed bracket together by screwing x4 screws into
the top of the bracket.
Hardware Used
AA
M4. 2x8 Screws
1
2
3
AA
x 4
ZCB100 Blower kit
6
Screws
Publicidad
