Descargar Imprimir esta página

Wirbel RAPID 15 E38 Uso Y Mantenimiento página 30

Ocultar thumbs Ver también para RAPID 15 E38:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 79
-
Move the machine near a main electrical
socket.
Charging procedure for BC and BC Lithi-
um versions:
- Unwind the cable (46) and connect it to
the outlet.
- Leave the batteries to charge until the
"Green" LED (47) comes on, then re-
move the power cable (46) and wind it
up in the specific support.
NOTE:
(for GEL batteries only) 10 hours are
needed for complete battery charging.
Avoid partial recharges.
NOTE:
(For lithium batteries only) It is possible to
recharge partial.
Charging procedure for BC Hybrid ver-
sion:
- Connect the socket of the extension to
the plug (36) of the machine.
- Connect the power cord to an outlet
having minimum capacity of 10A.
- The machine can be used while the
battery is recharging.
- After the battery has charged, coil the
cable (48), using the supplied strap
(21).
NOTE:
For more information on operating the
the charger see the operating manual at-
tached to the charger.
NOTE:
(For lithium batteries only) It is possible to
recharge partial.
WARNING:
- Make sure that the mains system is
equipped with an RCD (circuit breaker).
- Unwind the electric power cable com-
pletely before connecting it to the
mains socket.
- Use an electrical extension lead only
if in perfect condition; ensure that the
section is appropriate for the appliance
power rating.
- Never let the power cable run over
sharp edges and do not tread on it.
- The socket must be easily accessible.
6.1 CONTROL PANEL
24) LEDs status of battery charge
(only for BC version)
The button (26) is illuminated when
pressed, indicating the charging status of
the battery.
-
When the LED (24E) is illuminated, it
indicates that the battery charge sta-
tus is at maximum.
-
When the LED (24C) is illuminated, it
indicates that the battery charge sta-
tus is at about half.
-
When the LED (24A) is illuminated
(red LED), it indicates that the battery
charge status is at minimum.
With low battery (red LED (24A) on) the
machine shuts down or doesn't start up.
The red LED "R" flashes for a few sec-
onds indicating that the battery must be
charged (not for BC Long Runversion).
ENGLISH - 6
www.ghibliwirbel.com
Professional Cleaning Machines Since 1968
(Fig. 1)

Publicidad

loading

Este manual también es adecuado para:

Rapid 15 m38Rapid 15 m38 hybridRapid 15 m38 lithium