Descargar Imprimir esta página

MPM MOD-36 Manual De Usuario página 19

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 66
CLEANING AND MAINTENANCE
CAUTION! Never immerse the vacuum cleaner, the battery charger, the battery or the battery dock in water!
CAUTION! Empty the dust canister and clean the fi lters after each use for the best performance.
CAUTION! Maintain the vacuum cleaner powered off and disconnected from the battery charger!
1. Clean the outer surfaces of the vacuum cleaner with a damp cloth and wipe them dry. Use a
bit of a neutral detergent to remove persistent dirt.
2. Clean the mesh fi lter (12) and the motor fi lter (11) of dust with a fi ne brush. You can also wash
them under running water, but dry them thoroughly before reassembling. Wipe the inside of
the dust container with a damp cloth.
3. CAUTION! The fi lters must be completely dry before installation. Do not immerse the dust container in wa-
ter.Recharge the battery after each use. Do not store the vacuum cleaner with the discharged
battery. Use the supplied battery charger only. Do not short the battery poles. Use the iden-
tical battery type for replacement.
4. Regularly clean the rotary shaft of the electric brush. The shaft
can be detached after disengaging the lock in the bottom
part of the electric brush, indicated by an arrow in fi g. 10. After
cleaning the shaft, insert it into the electric brush and engage
the lock.
CAUTION! Do not dispose of used batteries with household waste. Dispose of
batteries by returning them to an authorized waste collection point or the
original reseller. Never throw batteries into fi re!
TROUBLESHOOTING
PROBLEM
The vacuum cleaner fails to start.
Low suction power.
The vacuum cleaner blows out dust.
MOD-36_instrukcja_v03.indd 19
MOD-36_instrukcja_v03.indd 19
CAUSE
Discharged battery.
Battery charging in progress.
Clogged wand and/or tool.
Dust canister full.
Clogged fi lters.
The dust canister is poorly installed.
Fig. 10
SOLUTION
Recharge the battery.
Wait until complete.
Unclog.
Empty the dust canister.
Clean the fi lters.
Install the dust canister properly.
05.05.2022 11:12:55
05.05.2022 11:12:55
19

Publicidad

loading