Timer-Recording Radio Programs - Sony MHC-RG77 Manual De Instrucciones

Recording to a tape (continued)
Recording a CD by specifying
track order
— Program Edit
You can record tracks from all the CDs in the
order you want. When programing, make sure
the playing times for each side do not exceed
the length of one side of the tape.
1
Insert a recordable tape into deck B,
then press CD.
2
Press PLAY MODE repeatedly until
"PROGRAM" appears in the display.
3
Press one of the DISC 1–3 button to
select a CD.
To program all the tracks on a CD at once,
proceed to step 6 while "AL" appears in the
display.
4
Press . or > repeatedly until the
tracks you want appears in the display.
5
Press ENTER.
The track(s) is (are) programmed. The
program step number appears, followed by
the total playing time.
6
To program additional tracks, repeat
steps 3 to 5.
Skip step 3 to select tracks from the same
disc.
7
Press CD SYNC HI-DUB.
Deck B standby for recording. The REC
PAUSE/START indicator flashes.
8
Press DIRECTION repeatedly to select
g to record on one side. Select j
(or RELAY) to record on both sides.
9
Press REC PAUSE/START.
Recording starts.
GB
14
To Do This
Cancel Program Edit Press PLAY MODE
repeatedly until "1 DISC" or
"ALL DISCS" appears in
the display.
Clear a track from Press CLEAR on the remote
the end when playback is stopped.
Tip
To check the required tape length for recording a CD,
press EDIT after you have loaded a CD and pressed
CD. The required tape length for the currently
selected CD appears, followed by the total playing
time for side A and side B respectively (Tape Select
Edit).
Note
You cannot use Tape Select Edit for discs containing
over 20 tracks.
Timer-recording radio
programs
To timer-record, you must preset the radio
station (see "Presetting radio stations" on
page 11) and set the clock (see "Setting the
clock" on page 8) beforehand.
1
Tune in the preset radio station (see
"Listening to the radio" on page 11).
2
Press CLOCK/TIMER SET on the
remote.
"DAILY1 SET" appears.
3
Press V or v repeatedly to select "REC
SET", then press ENTER.
"ON" appears and the hour indication flash
in the display.
4
Set the time to start recording.
Press V or v repeatedly to set the hour, then
press ENTER.
The minute indication starts flashing.
Press V or v repeatedly to set the minute,
then press ENTER.
The hour indication flashes again.
MHC-RG77 AR 4-238-409-63 (1)