Publicidad
Idiomas disponibles
Idiomas disponibles
Adjusting the display and mood light brightness
Press the
mood night (if mood light is on) from High-Middle-Low.
Turning on/ off the mood light
Press the
setting is mood light on).
There are 4 colors of mood light (green, light green, orange and red), that each
match the indicating icons of the air quality level on the display.
Troubleshooting
No display or functions
Check the AC/DC adaptor is properly connected.
Response time
Ensure the air flow channels at the back of the monitor are not blocked or covered.
reading shows "Err"
CO
2
The CO
sensor is not working properly. Unplug the AC/DC adapter
2
seconds to insert it to your monitor again.
Care and maintenance
Place your monitor on a stable surface, away from sources of direct sunlight or
excessive heat or moisture.
Clean your monitor with a soft cloth moistened only with mild soap and water.
Stronger agents such as Benzine, thinner or similar materials can damage the
surface of the item. Make sure the monitor is unplugged before cleaning.
Do not open the back case or tamper with any components of this monitor.
Do not plug in any other AC/AC or AC/DC adaptor with incorrect specifications
or voltage.
CO
levels and guidelines
2
Below are some CO
400~600 ppm
600~1,000 ppm
1,000 ~1,500 ppm
1,500~2,000 ppm
2,000~5,000 ppm
> 5,000 ppm
one at a time to adjust the brightness of the display and
button once at a time to turn on or off the mood light (factory
reference levels in general:
2
Background (normal) outdoor air level.
Typical level for occupied spaces with good air
exchange.
Start ventilation of the room.
Level associated with complaints of drowsiness and poor
air. Ventilation recommended!
Level associated with headaches, sleepiness, and
stagnant, stale, stuffy air. Poor concentration, loss of
attention, increased heart rate and slight nausea may
also be present. Ventilation strongly recommended!
Exposure may lead to serious oxygen deprivation
EN6
(C6)
for 10
Publicidad
