Publicidad
Idiomas disponibles
Idiomas disponibles
BEFORE YOU BEGIN
- The electic towel warmer must be installed by a qualified technician.
- Check that this towel warmer is compatible with the electrical system. The installer is
held solely responsible for installation.
- The installer must comply with the installation regulations in force in the country
where he operates.
- If an on-off and/or temperature control command is required, it must be reproduced
at the level of the electrical system by a qualified installer.
- Verify the presence of all items inside the package using the Packing List included
in the following page. Also verify that none of the components show visible defects.
- Care should be taken to avoid damage when installing or servicing the towel rails by
ensuring tools do not come into direct contact with the product service.
- If you should notice any defects please contact Devon&Devon immediately.
Devon&Devon retains the right to modify the product for technical or production
reasons. We will not be held responsible for any inconveniences caused by the above-
mentioned changes.
E
N
G
IMPLEMENTS REQUIRED
(NOT SUPPLIED BY DEVON&DEVON)
A. Measuring tape
B. Allen wrench (2mm)
C. Pencil
D. Drill + Wall bit
E. Level
F. Flat-tip screwdriver
A
B
D
F
E
78
PACKING LIST
(ELECTRIC TOWEL WARMER WITHOUT THERMOSTAT)
A1
C
A: Electric towel warmer supplied with exchanger liquid, electric heating element and
mains connection cable.
A1: Connection arm + hexagon socket
THE DRAWING REFERS TO A BASIC MODEL OF ELECTRIC TOWEL WARMER.
THE INSTRUCTIONS, REGARDLESS OF THE DESIGN, ARE ALWAYS THE SAME
A
FOR ALL MODELS OF ELECTRIC TOWEL WARMER.
79
E
N
G
Publicidad
