Publicidad
Idiomas disponibles
Idiomas disponibles
press the "II" button to increase (+) press the "I" button to
decrease (-) the assigned default value
once the parameter is modified, press the " OK button" to confirm,
as shown below in the figure
to exit the parameter menu, press the "ON OFF" button
Suggestion: to check the effectiveness of the rinse aid, look at glasses that were just washed up against the light. Drops
of water on the glass indicate that the amount is not sufficient, streaks indicate an excessive amount.
Replacing the type of detergent and rinse aid: If the type of detergent/rinse aid is being changed, even if it is the same
brand, the intake and delivery pipes must be rinsed with clean water before connecting the new detergent/rinse aid
container. Otherwise, the mixture between different types of detergent/rinse aid could cause crystallisation, possibly
causing the dispensing pump to break. Failure to observe this precaution annuls the warranty and manufacturer liability.
34.
MAINTENANCE
•
Once or twice a year, descale the boiler, the inner surfaces of the basin and the machine pipes.
Each month, descale the rinsing and washing jets in a bath of vinegar or descaling agent.
•
The tube inside the peristaltic rinse aid and detergent dispenser must be subjected to periodical maintenance (once
•
or twice a year).
Prolonged period of inactivity
If dishwashers remain unused for a long period of time, proceed as follows:
Close the supply water cock.
•
Completely empty the basin
•
•
Remove and clean the filter carefully
•
Completely empty the built-in dispenser tubes, removing the tubes from the cans
35.
INSTRUCTIONS FOR THE USER
Our equipment was designed to guarantee high performance levels and quality with regard to washing, filtering, noise
and energy savings. This equipment must only be used for the purpose for which it was expressly designed, which is
washing dishes with water and specific detergents. Any other use shall be considered improper.
WARNINGS:
•
Run a couple of empty cycles to clean the basin and all conductors of the production oils.
•
Do not wash decorated dishes
Prevent silverware from coming into contact with other metals
•
Avoid residue from drying on the dishes
•
Remove more consistent solid residue from the dishes to prevent clogging the filters
•
Pre-treat the dishes by rinsing them with cold or warm water, without using any detergent
•
Use the automatic dispensers for the detergent
•
•
If the automatic dispenser is not provided, pour non-foaming detergent in the basin when the water has
reached the washing temperature.
pag. 24
DOC. W010213 – REV.4
Publicidad
