Publicidad
Idiomas disponibles
Idiomas disponibles
Check that there is rinse aid in the container and fill it up if necessary.
CONDENSATE ON THE
Check the quantity of rinse aid used (see paragraph "dispenser adjustment").
GLASSWARE
Remove the basket with the glassware immediately after the cycle has ended
Use only "non foaming" products for professional dishwashers
SPOTS ON THE GLASSWARE
Check that the washing water temperature is not lower than 50°C.
Check if the detergent dispenser releases too much product (see paragraph
"dispenser adjustment").
EXCESSIVE PRESENCE OF FOAM IN
THE BASIN
Make sure that the basin was cleaned with suitable detergents.
If a foaming detergent was used, refill the basin with water until the foam has
disappeared.
GLASSWARE STREAKED OR
Reduce the amount of rinse aid (see paragraph "dispenser adjustment").
SPOTTED
Remove the arms and clean them thoroughly (see paragraph "3.4 end of service
THE WASHING AND/OR RINSING
and daily cleaning").
ARMS TURN SLOWLY
Clean the washing pump intake filter.
pag. 28
DOC. W010213 – REV.4
Publicidad
