Roger Technology H85/TDS Instrucciones Y Advertencias Para El Instalador página 21

12
Keypad acquisition procedure on the H85/DEC2 interface
Plug and Play Mode.
When using a single H85/TDS keypad, the acquisition procedure is automatic.
POWER ON
ON
• Power on. The L1, A, B
• The green L1 LED stays lit for about 5 s.
• If the keypad is detected, the L1 LED blinks rapidly, and acquisition has been successful.
• If the keypad is not detected, the L1 LED goes out. Check the connection between interface and keypad.
Dual Keypad Mode.
When using two H85/TDS keypads, or if installing a second keypad at a later time, the acquisition procedure is as
There are 2 indicator LEDs (A, B) rather than 4.
13
ATTENTION!
It is NOT possible to store the user code 0000.
It is NOT possible to store a user code that is the same as the password (example: user code 1234 and password
1234).
Example 1: memorization of user code 34741, password 0000, enabling of all function keys 1/A, 4/B, 7/C, */D digit:
If the procedure is successful the green LV LED lights up for 2 s. The buzzer sounds until the LED goes out.
Example 2: memorization of user code 34741, password 0000, enable only function key 4/B digit:
If the procedure is successful the green LV LED lights up for 2 s. The buzzer sounds until the LED goes out.
N.B.: if the password entered is correct, the red LR LED will light up. If it doesn't light up, check the password has been
entered correctly.
13.1
Activating a user code
Enter the previously stored user code with multiple channel functions followed (e.g. 34741) by an asterisk (*).
If the code has been stored in the memory, the keypad's green LV LED lights up.
Press and hold the enabled key/channel (e.g. 4/B - CH_B).
Example:
If ONLY ONE of the channels CH is enabled (1/A...4/B ...7/C...*/D), the associated OUT relay is activated immediately
after entering the user code followed by * (asterisk):
EXAMPLE with user code 89512 and only CH_A enabled.
NOTE: activation of the OUT output is maintained as long as the asterisk (*) key is pressed; when the key is released,
the H85/TDR keypad goes to stand-by.
WARNING!
• A maximum of 5 s may elapse between pressing one key and the next, otherwise an error alert is activated (the red
L1
LED L1
STAYS LIT for 5 s
* 0000 * (the red LR LED lights up) 34741 # #
* 0000 * (the red LR LED lights up) 34741 # B #
34741 * B
89512 * (CH_A transmit)
L1
LED L1
BLINKS
RAPIDLY
0000.
21