Publicidad
Idiomas disponibles
Idiomas disponibles
Grounding installation
This appliance is classified as protection class I and must be
connected to a protective ground. Grounding reduces the risk
of electric shock by providing an escape wire for the electric
current.
This appliance is fitted with a power cord with grounding plug
or electrical connections with grounding wire. The connec-
tions must be properly installed and grounded.
Main parts of the product
(Fig.1 on page 3)
1. Power switch (0 / I)
2. Speed dial (clockwise, Low to Hight)
3. Pulse button
4. Bottom of the motor base unit
5. Motor unit
6. Blade assembly
7. Jug set
8. Jug lid
9. Cover cap
10. Protective cover
Remark: The content of this manual applies for all listed
items unless specified otherwise. The appearance may vary
from the shown illustrations.
Circuit diagram
(Fig.2 on page 3)
L1 & L2: Magnetic ring
MS1: Micro switch
MS2: Magnetic safety micro switch
PCB: Main PCB
S: Power switch
R: Variable resistor
P: Pulse button
M: Motor
Exploded diagram with part list
(Fig.3 on page 4)
Part no.
Part name
1
Cap cover
2
Jug lid
3
Stamper (not supplied)
4
Protective cover (rear)
5
Jug set
6
Protective cover rubber sealing (rear)
7
Blade assembly
8
Seal ring of the blade assembly
9
Large seal ring
10
Mounting screw
11
Clutch
12
Jug holder
13
Jug holder support
14
Rubber seal cover
15
16
17
18
Mounting screws for the micro switch
19
20
21
22
23
24
25
26
27
28
Protective cover rubber sealing (rear)
29
30
31
32
33
34
35
36
37
38
39
40
Mounting screws for the micro switch
Quantity
1
41
1
42
1
43
1
44
1
Preparation before use
1
• Remove all protective packaging and wrapping.
• Check that the device is in good condition and with all acces-
1
sories. In case of incomplete or damaged delivery, please
1
contact the supplier immediately. In this case, do not use
the device.
1
• Clean the accessories and the appliance before use (See ==>
1
Cleaning & Maintenance).
• Make sure the appliance is completely dry.
1
• Place the appliance on a horizontal, stable and heat resist-
1
ant surface that is safe against water splashes.
• Keep the packaging if you intend to store your appliance in
1
the future.
1
• Keep the user manual for future reference.
Motor outer housing
Safety micro switch assembly
Internal wire terminal for safety
micro switch
Power plug
Power cord
Power cord clamp
Motor assembly
Cap cover
Jug lid
Stamper (not supplied)
Protective cover (rear)
Jug set
Blade assembly
Seal ring of the blade assembly
Large seal ring
Mounting screw
Clutch
Jug holder
Jug holder support
Rubber seal cover
Motor outer housing
Safety micro switch assembly
Internal wire terminal for safety
micro switch
Power plug
Power cord
Power cord clamp
Motor assembly
1
GB
1
1
2
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
2
1
1
1
1
9
Publicidad
