(7) Reposition the track so the rear end and
anti-chip strip edge of the track extends
slightly past the end and edge of the table.
Slide the saw back to the rear of the track
with the rear of the saw overhanging the
end of the track enough to allow access
to the rear toe-in adjustment screws.
(8) Insert a business card or construction
paper approximately 0.010" thick between
a blade tooth and the anti-chip strip at the
rear of the blade. This sets the proper
blade toe-in.
(9) Tighten both rear toe-in adjustment
screws. Remove saw from the track and
tighten the second front toe-in adjustment
screw. Verify all four toe-in adjustment
screws are tight.
SETUP
9
9
7
8