Intex PureSpa SSP-H-20-1C Manual Del Propietário página 6

• Always keep plug dry, plug in with wet plug is defi nitely forbidden!
• The plug of SPA must be directly connected only to a earthed socket-outlet from a fi xed electrical
installation.
• To reduce the risk of electric shock, do not use extension cords, timers, plug adaptors or converter
plugs to connect unit to electrical supply; provide a properly located outlet.
• Do not attempt to plug in or unplug this product while standing in water or when your hands are wet.
• Do not leave the spa empty for extended period of time. Do not expose the spa to direct sunlight for
extended period of time.
• When the appliance is not in use for long period of time, such as in the winter, the spa set should be
disassembled and stored indoor.
• Do not allow the water in the spa to freeze. Do not turn on the spa when the water is frozen.
• Do not use the spa if damaged in delivery and/or malfunctioning in any fashion. Contact the Intex
service center for further direction.
• Never use the spa alone or allow others to use the spa alone.
• Never pour water with a temperature higher than 40°C (104°F) into the spa directly.
• Keep all pets away from spa to avoid any damage.
• Do not add bath oil or bath salt to the spa water.
• The spa must be setup on a level, fl at and smooth surface that is capable of supporting the
maximum load of the fi lled spa with four adult occupants: weight 1136 kg (2500 lbs); six
adults: 1592 kg (3500 lbs).
• Provide adequate drainage system around the spa to deal with overfl ow water and splashes.
• This product is provided with a RCD located at the end of the power cord. The RCD must be
tested before each use. Do not use the spa if the RCD does not function properly. Disconnect
the power cord until the fault has been identifi ed and corrected. Contact a qualifi ed electrician to
correct the fault. Do not bypass the RCD. There are no serviceable parts inside the RCD.
Opening the RCD will void the warranty.
1. Press the RESET button on the RCD.
2. Turn on the spa electrical equipment.
3. Press the TEST button on the RCD. The RCD indicator should turn
off and the electrical equipment should shut off. If the RCD indicator
does not turn off, and the electrical equipment does not shut off, the
RCD is faulty. Do not use the spa. Contact a qualifi ed electrician to
correct the fault.
4. Press the RESET button on the RCD. The indicator on the RCD
should turn on. If the RCD indicator does not turn on, the RCD is
faulty. Do not use the spa. Contact a qualifi ed electrician
immediately to correct the fault.
• Maintain water chemistry in accordance with manufacturer's instructions.
S AVE THESE INSTRUCTIONS
(295IO) SPA ENGLISH 7.5" X 10.3" PANTONE 295U 08/20/2016
WARNING
WARNING
CAUTION
English
RESET
RESET
TEST
RESET
TEST
RESET
TEST
TEST
TEST
Page 5
295
A