Publicidad
Idiomas disponibles
Idiomas disponibles
SET UP & USE
WATER DRAINAGE FOR COOL AND HEAT MODES
This air conditioner is equipped with auto water evaporation so the water compartment
would not typically fill in cooling or heating mode unless there is high humidity. Water
drainage will generally only be required at the end of the season for these modes. (see
START-END OF SEASON OPERATIONS).
NOTE: When an error code appears on the display screen on the control panel "E2" in
COOL or DEHUMIDIFY mode, or "E4" in HEAT mode, the unit will have to be
drained.
Intermittent Draining
•
Unplug the unit from the power source. Carefully move the unit to a drain area
over your basement floor or drip pan (not included). Remove the bottom drain
cap.
• Let the water drain away and replace the drain cap. Restart the machine until the
error codes E2 or E4 disappears. If the error repeats, call for service.
NOTE: Be sure to reinstall the bottom drain plug before using the unit.
Continuous Draining
• Unplug the unit from the power source. Remove the bottom drain cap. While
doing this operation, some residual water may spill. Have a drip pan (not
supplied) to collect the water.
• Connect the drain hose (supplied) as shown in the diagram. The water can be
continuously drained through the hose into a floor drain or drip tray.
• Turn on the unit.
Drain outlet
Drain hose
WAIT 3 MINUTES BEFORE RESUMING OPERATION
• After the unit has stopped, it cannot be restarted for 3 minutes. Operation will
automatically restart after 3 minutes.
Page 20
Drain cap
Publicidad
