70mai M500 Manual De Instrucciones página 4

3. Connecting the power cord
Connect the power cord to the Type-C power port
sure that it is well connected.
4. Pasting the bracket
Rotate the mount of the bracket and make the heat resistant adhesive face toward the front
windshield.
Peel off the protective film from the heat resistant adhesive, and paste the bracket on the
electrostatic sticker in the dotted area.
Press the mount to make sure it is firmly attached on the electrostatic sticker.
5. Connecting the power supply
As shown in the figure, run the power cord along the top of the windshield, down the A-pillar, and
around the glove compartment, so that the power connector is near the cigarette lighter. Connect
the power cord to the car charger, then plug the charger into the cigarette lighter socket.
Notes:
●
Use the included crowbar to hide the power cord underneath the vehicle's headliner and rubber seal
along the A-pillar.
●
Depending on the vehicle, the cigarette lighter socket may be located in a different position. The figure
provided is for reference only.
6.
Adjusting the dash cam angle
Connect the dash cam with the 70mai app following the instructions on the user guide.
Turn on the dash cam and adjust the camera angle based on the preview screen on the app.
Type-C power port of the dasm cam. Pull the power cord to make
02