Installation - AEG L61470WDBI Manual De Instrucciones

Problem
The laundry is full of dif-
ferent coloured fluff:
After the check, activate the appliance.
The programme continues from the
point of interruption.
If the problem occurs again, contact the
Authorised Service Centre.

16. INSTALLATION

16.1 Unpacking
WARNING!
Remove all the packaging and the transit bolts before installing the
appliance.
Possible solution
The fabrics washed in the previous cycle released fluff of a dif-
ferent colour.
• Clean the clothes with a fluff remover
• The drying phase helps to eliminate some fluff.
In case of an excessive amount of fluff in the drum, refer to sec-
tion «FLUFF IN THE FABRICS».
• Thoroughly clean the empty drum, the gasket and the door
with a wet rag.
• Perform a rinse cycle.
• Put a wool or piled fabric rag inside the drum.
• Perform a drying cycle of 10 minutes.
• Remove the old wool cloth.
Now you can wash other garments.
If the display shows other alarm codes.
Deactivate and activate the appliance. If
the problem continues, contact the
Service.
Use the gloves. Remove the external film. If
necessary, use a cutter.
ENGLISH 27