Fanaway LD-0003-10/WH/GS/E27 Manual De Instrucciones página 7

INSTALL THE DOWN ROD
1) Feed down rod through ceiling canopy (No.3– Fig. 1) and bolt and pin cover (No.6– Fig. 1).
2) Loose ball joint and insert the motor wires through down rod, and then secure ball joint back to down rod.
3) Insert down rod (No.4– Fig. 1) to the top of the unit (No.8– Fig. 1), line up unit holes with down rod holes
and insert bolt (No.5– Fig. 1). Then insert pin (No.7– Fig. 1) to end of bolt.
4) Finally secure down rod and hanger via tightening two screws on the hanger.
INSTALL THE FAN TO MOUNTING BRACKET ON CEILING
1) Lift the fan to the ceiling and seat the ball joint in mounting bracket socket, make sure the tab on the
mounting bracket socket is properly seated in the groove in the ball joint.
2) Connect the male plug (Fan Motor) and female plug (Mounting bracket) together (No. 1 - Fig. 3).
3) Then slide the ceiling canopy (No.3– Fig. 1) onto the mounting bracket using the slotted holes. Align the
other 2 holes and then install the 2 other screws. Tighten all four screws firmly.
INSTALL THE LIGHT KIT
Install light kit and screw light base (No.11-Fig.1) firmly to the fan. Do not over-tighten. Plug the plug and
socket together. Install the wire cover (No.12-Fig.1) to light base. Install bulbs (not included). Finally install the
light dome to light base via turning it clockwise.
Figure 4
7