Titanium OfficeProfessional Plus A3 Manual De Instrucciones página 14

Please observe the following information to ensure reliable operation of the laminator:
- Read this manual thoroughly and observe the instructions and information in it when operating the device.
- Keep the operating manual in a safe place for future reference.
-The device may only be operated indoors in dry rooms which are well ventilated.
- The device must be set down on a level surface and may only be used when horizontal.
- Do not use the device in the vicinity of hot surfaces or in damp environments and protect it from direct
sunlight and dusty conditions.
- Ensure that the power switch is in the "OFF" position before connecting the laminator to the mains power
supply.
- The mains power socket and power connection on the device must be freely accessible for reasons of safety,
namely to enable the power supply to be disconnected quickly in an emergency!
- Switch the device o immediately if a strong smell comes from it.
- Switch the device o when it is not being used.
- Disconnect the power plug when the device is not in use.
- Prevent damage to the power plug and power cable. Never twist or kink the power cable nor set it down
on hot surfaces. Do not operate the device if the power cable or power plug is damaged.
- Never take hold of the power plug with damp hands.
- Keep loose clothing, ties, jewellery, long hair and other loose objects away from the device. Risk of injury!
- Children must not be allowed in the vicinity of the device when it is ready to operate.
- Ensure no pets can get near the device.
- Always use the lamination foil pockets recommended for the device (refer to "Features"). Using lamination
foil which is too large could lead to the unit jamming.
- Do not use foil pockets intended for cold lamination for hot lamination. This could damage the device, foil
pockets and document.
- Never cut lamination foil to size. The resulting cut edges could cause the lamination foil to jam.
- Never use foil pockets which are soiled. Clean them beforehand, if necessary, using a soft, slightly
damp cloth.
- Metallic objects cannot be laminated.
- Do not laminate heat sensitive materials, such as thermal paper, in thedevice.
- Lamination of moist documents produces poor results.
- Maintain a pause of at least 15 seconds between each laminationprocess.
- Allow the device to cool down for at least 30 minutes after use.
- Only transport the device when it is in a cool state.
- Never touch hot parts of the device. Risk of burns! Handle the foilpockets just laminated with due care
and attention. They are very hot!
14