Publicidad
Idiomas disponibles
Idiomas disponibles
1. Connect the power cable to an easily accessible, standard electrical socket.
Attention: Check that the voltage speci cations of the machine correspond to that of your power supply
network (220 - 240 V / 50 Hz).
2. Switch on the power switch on the rear side of the device.
3. Press the On/O button on the operating panel to switch the device on. The drive motor for the transport
rollers starts up.
4. Press the button for selecting cold/hot laminating and foil thickness, several times if
necessary, until the COLD LED lights up in the operatingpanel. The LED strip lights up blue, continually, when
the device is ready for use. Attention: If you have just nished using the laminator for hot laminat-
ing, you must let the laminator cool down. The equipment takes about 30 minutes to cool down. The LED
strip ashes red during the cool down phase.
5. Insert the document to be laminated in the foil pocket so
that there is a margin of approx. 3-5 mm to the edge of the foil on all sides.
6. Insert the foil pocket containing
the document in the laminator's infeed slot. Insert the ready closed side of the foil in rst. The laminating pro-
cess occurs automatically.
Note: To prevent the foil pocket from creasing, never feed the open side of the laminating pocket rst in the
infeed slot of the laminator. Note: If the device remains unused for 30 minutes, it switches o automatically.
Press the On/O button on the operating panel to switch the device on again.
7. When you have nished your laminating tasks, press the On/O button on the operating panel to switch
the device o . Switch o the power switch on the rear side of the device. Also disconnect the power plug,
particularly when the device will remain out of operation for a longer period.
17
Publicidad
