Zizito TOMMY Manual De Instrucciones página 4

5. INSTALLATION OF THE FRONT WHEEL
EN
6. ADJUSTING THE SADDLE
Loosen the saddle support nut, adjust the
saddle height and direction. Make sure that
the front wheel, saddle and rear wheel are
aligned.
1. Loosen the saddle pin nut. Adjust the saddle height to the rider's height. Adjust the handlebar
height, and adjust the depth, more than 5 cm.
2.The new bike should be accepted and do a thorough check after a week or so of use and
tighten all the nuts and bolts of the parts to ensure normal operation.
3. As for the moving parts, they should be kept in excellent lubrication condition to prolong the
service life of use. In general, it should be disassembled and assembled every half year, and
add new oil.
1. Bicycles with wheel sizes of 12 inches are designed for children from 3 to 5 years.
These bikes are used around living spaces, park alleys, paths. They must not be used on roads
and streets used by cars, near stairs and swimming pools.
2. The minimum seat height shall be 550 mm measured from the floor to the top of the seat.
3. The front and rear brakes are mechanical - jaws type / with valve /.
When the bike has two brakes, use both. To stop safely, apply the front handle and the rear
brake handle with equal force. Caution: If you apply much more force to the front brake lever,
you may fly over the handlebars.
4
Insert the front wheel on the fork leg. The hook of the locking ring must
be connected to the connecting hole of the fork. The ring is placed on
the front wheel lever. Adjust the distance between the front wheel and
the bracket on both sides and equalize it, tighten the nut. (Use an adjust-
able wrench to tighten the axle nuts to 18 N.m. of torque each).
USE PROTECTION
IMPORTANT SAFETY NOTICE