monzana DBWH003 Manual De Instrucciones página 9

INTENDED USE
This product is a hydraulic floor jack for lifting motor vehicles. It is purely a lifting device. Make
sure that the load to be lifted does not exceed the jack's rated load. Under no circumstances may
the load be exceeded, otherwise damage may occur and safety is no longer guaranteed. Only use
the jack on solid, level ground. Load instability and slippage may occur on soft ground. It is then
impossible to rule out consequential damage to both people and the vehicle.
Use the product only for the purpose it is intended for. The manufacturer accepts no liability for
damage caused by unintended use. Any modification to the product may negatively impact safety,
cause hazards and invalidate the warranty.
Only suitable for domestic use; not for commercial use.
UNPACKING INSTRUCTIONS
Open the box and remove the product.
After unpacking, please check the product for damage and to ensure it is complete. Subsequent
complaints cannot be accepted.
OPERATION
Important:
Before lifting your vehicle with the jack, read the instruction manual for your vehicle. Use the points
mentioned in it for lifting.
Lifting the load:
Close the relief valve by turning it clockwise. Position the jack under the load so that the load
support is firmly connected to the load. Centre the load so that it can no longer slip. Push the
handle of the jack until the load pick-up reaches the load. Check again that the load pick-up is still
in the correct position. Raise the load to its desired height. Make sure that the jack does not lift
more than the maximum load. Do not crawl under your vehicle while the vehicle is being lifted or
9 www.DEUBAXXL.de