Pit Boss PB5BGD1 Manual De Instrucciones página 11

If the burner goes out during operation, turn the control knobs to the OFF position. Wait five minutes before
attempting to relight to allow any accumulated gas to dissipate.
IGNITER FAILURE PROCEDURE
If for any reason your igniter fails after three of four attempts, check the following steps, or start your griddle using
the manual method.
1. Ensure the control knobs are turned to the OFF position. Allow any accumulated gas to dissipate.
2. After five minutes, check the following:
• Visually confirm that the igniter is working by pushing the igniter button and looking at the igniter tip for a spark. If
no spark, replace the battery in the lighter button or adjust the distance between the igniter (electrode) tip and burner
to 4.5 mm (3/16 in).
• Visually confirm that the burner tube and portholes are not obstructed. If blocked, follow Care & Maintenance
instructions .
3. If the above points do not work, follow Troubleshooting instructions .
1. Verify that the control knob is turned to the OFF position.
2. Connect LP gas cylinder as per instructions. Turn LP gas tank valve to OPEN.
3. Note the indicator marker on the control knob. Push in the regulator knob and turn 90 degrees (or 1/4) counter-clockwise
to HIGH.
4. Quickly and carefully, use a lit match secured with the lighting rod (included with the griddle) to light burners. Access the
burners through the hot plate. Position lit match near side of burner. Do not attempt to light another area of the burner.
This can cause injury.
NOTE: Do not use spirit, lighter-fluid, or kerosene for lighting or refreshing a fire in your griddle.
5. After the burner has caught fire, you are ready to enjoy your griddle at your desired temperature!
1. When finished cooking, turn LP gas tank valve to the CLOSED position, and allow the regulator knob to pop out. This safety
feature locks the regulator knob to ensure that the gas is no longer flowing.
2. Turn control knobs to the OFF position.
NOTE: A "poof" sound is normal as the last of the LP gas is burned.
3. Disconnect LP gas tank by following the Disconnect LP Gas Tank instructions.
WARNING: Allow the griddle to cool completely, and remove the gas cylinder, before moving, travel, or for
storage.
WWW.PITBOSS-GRILLS.COM
MANUAL LIGHTING PROCEDURE
SHUTTING OFF YOUR GRIDDLE
11 PIT BOSS® GRILLS