Pit Boss PB5BGD1 Manual De Instrucciones página 8

The griddle is set and tested with liquid propane gas only. The regulator supplied is set for 27.94 cm (11 inch) water column (WC)
and is for use with LP gas only. The factory-supplied regulator and hose must be used with a 9 kg (20 lbs) LP gas tank. Contact
your gas supplier for a special regulator for bulk gas that fuels other appliances.
CAUTION: It is important to inspect the full length of the gas line hose. If it is evident there is excessive abrasion or
wear, or the hose is cut, the hose must be replaced prior to the appliance being used.
1. From the side of the cart (A), place foot ring of 9 kg (20 lbs) tank onto
the gas tank hook (B) and bracket (C). Make sure the tank valve is in
OFF position. Ensure the tank is completely upright, as it is unsafe to
operate the griddle if the gas tank is not installed properly.
2. Ensure the regulator valve on the griddle is completely closed by
turning the knob clockwise to the OFF position.
3. Remove the protective caps from the regulator valve opening and the
top of the gas cylinder. Save the caps.
4. Insert the gas cylinder valve into the threaded opening of the regulator
valve. Turn the quick coupling nut clockwise until firm. Hand-tighten
only (D).
5. Gas cylinder is now installed.
The outdoor griddle, when installed, must be electrically grounded in
accordance with local codes or, in the absence of local codes with the
National Electrical Code ANSI/NFPA 70, or Canadian Electrical Code, CSA
C22.1.
1. Do not store a spare LP gas tank under or near this appliance.
2. Never fill the tank beyond 80 percent full.
3. If the information in 1) and 2) is not followed exactly a fire causing
death or serious injury may occur.
4. Place dust cap on cylinder valve outlet whenever the cylinder is not in
use. Only install the type of dust cap on the cylinder valve outlet that
is provided with the cylinder valve. Other types of caps or plugs may
result in leakage of propane.
5. The LP gas tank used must have a collar to protect the tank valve.
6. Always keep the LP cylinder at 90 degrees (upright) orientation to
provide vapor withdrawal.
PIT BOSS® GRILLS
CONNECTING TO A GAS SUPPLY
GAS CYLINDER REQUIREMENTS
INSTALLING A GAS CYLINDER
8
A
B C
D
WWW.PITBOSS-GRILLS.COM