Publicidad
Idiomas disponibles
Idiomas disponibles
II. Laying the shock-absorbing surface
Note: Both tracks (7) and (8) are longer than the 25.50 m dynamic structure. Leave them to rest until they are flat (no more
than 2 days), before cutting off one end of it if the selected configuration so requires. Use a perfectly straight rule at least
2 m in length and a cutting tool such as a trimming knife (be careful with the underlying material).
1 - For track without markings (Ref.: 6298/30):
Unroll the track (7) upside down, aligned widthwise with the uprights (1): carpet side against the fiber rods (2),
(see Figure 10). Set its start position to suit user needs: generally at the start of the first panel (6).
2 - For track with GYMNOVA screen printing (Ref.: 6298/40):
Unroll the second track (8) right side up, aligned widthwise with the uprights (1): carpet side up, such that the non-slip
surfaces of the 2 tracks are in contact. Set its start position to the first track (7).
Non-slip surfaces
in contact
III. Join up the assembly using 36 Velcro links (as shown in Fig. 11 and 12):
1 - At each link between 2 dynamic panels (6), ensure that the uprights (1), either side of the track are fully in contact.
Next, thread a strip of red Velcro (9) keeping it flat through the 2 triangular rings (4) facing each other, with the hook
side visible, the even out its length in order to ensure hook-up is symmetrical (see Figure 11).
2 - Cross over then tighten each Velcro strip (9), before folding the ends over the top of the upper track (8), in order to
hold the assembly together (dynamic structure and shock-absorbing surface).
3 - Repeat the procedure for the 32 links.
4 - Finish at the 4 corners of the track, with the Velcro strip (9) in a full loop through the last ring (4) (see Figure 12).
Figure 11
8
7
1
4
IV. Applying the markings (as shown in Fig. 13 ):
3 strips of beige Velcro (10) are provided in the track length (25.50 m): 2 to delimit the 1.50 m wide tumbling corridor and 1
positioned centrally for guidance. The 3 remaining shorter strips (11) are used as a visual marker for the last contact, their
positioning is left to the discretion of each user.
(minimum of two people required)
8
7
1
4
9
10
8
10
10
:
1
17
Carpet
1
1
9
4
18 14
16
15
11
NM246a-
Figure 10
8
7
Figure 12
Figure 13
Page 3
Publicidad
