Marshall JTM45 2245 Guia De Inicio Rapido página 7

REAR PANEL FUNCTIONS
1 & 2. SPEAKER OUTPUTS
Connect one or two speaker cabinets here
using 1/4" jack speaker cables.
Warning:
always ensure the output impedance
selector is set to the appropriate impedance for
the load of your setup (speaker cabinets). Never
use this amp without a speaker or load.
3. OUTPUT IMPEDANCE SELECTOR
Matches the amp's output to the load
impedance. Ensure the amp is completely
powered down before turning the selector.
The impedance selected on the amp must
match the total impedance of the speaker
cabinet(s) being used. Common setups include:
• If the amp is running into a single 16Ω cab,
the selector should be set to 16Ω.
• If running into two 16Ω cabs, the selector
should be set to 8Ω.
• If running into two 8Ω cabs, the selector
should be set to 4Ω.
Warning: failure to comply with these points
may damage the amp.
4. H.T. FUSE
The correct value of H.T. fuse is specified on
the panel.
5. POWER INLET
The supplied mains power lead is connected
here. The mains input voltage rating that your
amp has been built for is shown on the rear
panel.
1 2 3 4 5
6. MAINS FUSE
The correct value of mains fuse is specified on
the rear panel.
ENGLISH
6
5