Publicidad
Idiomas disponibles
Idiomas disponibles
PRODUCT OVERVIEW
The cordless pruning shears are only intended for cutting wood. The pruning shears' electric drive allows them to be used under
a canopy or near buildings. Thanks to the battery power supply, the pruning shears allow you to work in places where mains-pow-
ered products could not be used. The pruning shears are used to cut branches and trim shrubs and bushes. Proper, reliable and
safe operation of the tool depends on appropriate use, that is why you should
Read the entire instructions manual before the first use of the tool and keep it for future reference.
The supplier shall not be held liable for any damage or injury resulting from improper use of the tool, failure to observe the safety
regulations and recommendations of this manual. Using the tool for purposes other than those for which it was intended shall
cause the loss of the user's rights to a warranty and statutory warranty.
PRODUCT EQUIPMENT
The pruning shears are supplied complete but requires assembly before first use. The tool is supplied with: wrenches necessary
for its adjustment. The battery and charging station (charger) are only provided with the YT-828377 product. The YT-828378
product is not provided with a battery and charger.
TECHNICAL DATA
Parameter
Catalogue No.
Rated voltage
Max. cutting diameter
Electrical protection class
Weight (without battery):
Noise level
- L
(pressure)
pA
- L
(power)
wA
Vibration a
(front and rear handle)
h
Battery type
Battery capacity*
Battery energy
Charger*
Input voltage
Mains frequency
Rated power
Output voltage
Output current
Charging time**
* only for models equipped with a battery and charger
** the specified charging time applies only to the battery with the capacity listed in the table
The declared noise emission value has been measured using the standard test method and can be used to compare one tool to
another. The declared noise emission value can be used in the preliminary exposure assessment.
The declared total vibration value has been measured using the standard test method and can be used to compare one tool to
another. The declared total vibration value can be used in the initial exposure assessment.
Caution! The vibration emission during tool operation may differ from the declared value, depending on the manner the tool is used.
Caution! Safety measures to protect the operator, which are based on an assessment of exposure under actual conditions of
use (including all parts of the work cycle, such as the time when the tool is switched off or idle and the activation time), must be
specified.
GENERAL WARNINGS FOR THE SAFETY OF POWER TOOLS
Warning! Read all safety warnings, illustrations and specifications provided with this power tool. Failure to do so may
result in electric shock, fire or serious injury.
Keep all warnings and instructions for future reference.
O R I G I N A L
12
EN
Unit
[V]
[mm]
[kg]
[dB] (A)
[dB] (A)
[m/s
]
2
[Ah]
[Wh]
[V~]
[Hz]
[W]
[V]
[A]
[h]
I N S T R U C T I O N S
Value
YT-828377, YT-828378
18 d.c.
30
III
0.9
67.0 ± 3.0
78.0 ± 3.0
1.5 ± 1.5
Li-ION
2
36
220 - 240
50/60
60
21 D.C.
2.4
1
Publicidad
