Descargar Imprimir esta página

Matfer 121164 Instrucciones De Uso Y Mantenimiento página 5

Publicidad

Idiomas disponibles

Idiomas disponibles

SPECIAL INSTRUCTIONS
- If the power supply soft cable is damaged, it must be repaired by manufacturers,
service sectors or maintenance workers to avoid damaging the machine or serious
injury to the personnel.
maximum temperature is 230°C; reset temperature is less then 170°C.
- There is an abort button for over-heating on the side. If temperature goes over the
limit, press the abort button to restart.
with 170°C, to deconect protection. The apparatus starts only when the button of
protection goes back to zero.
If the circuit breaker repeats the action, called upon the technician specialized to carry
out a repair.
- Install a circuit breaker of escape to the standards, for the electric connection of the
apparatus.
- The high temperature is likely to burn the human body. Directly do not touch the oil
tank because of the high temperature.
- Leave to dry in an open area and out of the reach of children.
- Installation of this machine should be done by an authorized technician.
- If the power supply soft cable is damaged, it must be repaired by maintenance
workers to avoid damaging the machine or serious injury to the personnel.
MAINTENANCE
- Before washing the apparatus, you ensure that it is disconnected.
-
Don't wash the machine with water directly to avoid electric leakage and component
damage.
- To drain waste oil, let first cool oil until the room temperature. Shut off the electric current,
place a container under the drainage sluice and open this valve.
For the model without draining, the tank is dismountable to facilitate cleaning.
- Cut off the power supply before cleaning to prevent damage.
-
Keep the stick and hollowware clean with a sponge and a grease-removing product.
-
Before stopping the machine, make sure that the thermos and power are switched off.
- The separating oil grid is installed to ensure the heaters protection .
At the crackling time, this separating panel must be posed in the oil tank.
- If the machine is not in use turn off the temperature switch and the power switch. Store
the machine in a ventilated area away from corrosive gases.
There is a constant temperature in the electric terminal box. The
It is necessary to wait the fall in the temperature
ENGLISH

Publicidad

loading

Productos relacionados para Matfer 121164

Este manual también es adecuado para:

121166121168121178121182