Publicidad
Idiomas disponibles
Idiomas disponibles
The following examination should be carried out prior to any use:
1. The various parts of the assembly table should not be bent or twisted.
2. Test the functioning of the brakes and check the wheels for wear.
3. Lubricate the moving, wearing parts prior to use.
4. If there are defects, repairs should be carried out promptly.
5. The pipe guides and the lifting spindle should be lubricated once per month.
USAGE
1. In order to adjust the assembly table to the length of the mounting plate, wind the work surface into the
horizontal position. Remove the split rivet (1) on the lower pull-out part. Afterwards, loosen the locking
screws (2) and adjust to the desired length. Now the locking screws are to be tightened again and the
split rivet re- inserted. On the upper pull-out part only the two locking screws have to be loosened to set
the desired length. Afterwards the locking screws should be tightened again and the work surface is set
to the length of the mounting plate. Now place the mounting plates on the work surface.
2. In order to set the lower pull-out part to the width of the mounting plate, the work surface must be in the
horizontal position. Loosen the clamping lever (3) and adjust the adapter plates to the desired width. The
adapter plates must be positioned in such a way that the screwed-in knurled thumb screw fits tightly on
the inner side of the mounting, plate's U-section. After adjusting the width, tighten the clamping lever
again. Now screw in the knurled thumb screws.
8
Publicidad
