JVC KD-T922BT Manual De Instrucciones página 40

Display Settings
Zone identification for color settings
KD-T922BT:
KD-X38MDBT:
1
Press and hold .
2
Turn the volume knob to select an item (see the following table), then
press the knob.
3
Repeat step 2 until the desired item is selected/activated or follow the
instructions stated on the selected item.
4
Press to exit.
To return to the previous setting item, press
32 ENGLISH
[DISPLAY]
[DIMMER]
[BRIGHTNESS]
[TEXT SCROLL]*2 [SCROLL ONCE]: Scrolls the display information once. ;
[FORMAT]*3
*1 The illumination control wire connection is required. (Page 42, 43)
*2 Some characters or symbols will not be shown correctly (or will be blank).
*3 Functionality depends on the type of phone used.
.
Dims the illumination.
[OFF]: Dimmer is turned off. Brightness changes to [DAY] setting.
[ON]: Dimmer is turned on. Brightness changes to [NIGHT] setting.
(See the following "[BRIGHTNESS]" settings.)
[DIMMER TIME]: Set the time to turn on dimmer and to turn off dimmer.
1 Turn the volume knob to adjust the [ON] time, then press the knob.
2 Turn the volume knob to adjust the [OFF] time, then press the knob.
(Default: [ON]: [18:00] ; [OFF]: [6:00])
[DIMMER AUTO]: Dimmer turns on and off automatically when you turn off
or on the car headlights.*1
Sets the brightness for day and night separately.
1 [DAY]/[NIGHT]: Select day or night.
2 Select a zone. (See the illustration on page 31.)
3 [LEVEL 00] to [LEVEL 31]: Set the brightness level.
[SCROLL AUTO]: Repeats scrolling at 5-second intervals. ;
[SCROLL OFF]: Cancels.
• KD-DB622BT/KD-X38MDBT: Not applicable to Dynamic Label display
information (page 35, 36) while in DAB source.
(For KD-T922BT/KD-X38MDBT)
Information below is shown on the supplementary display when Bluetooth
device is connected. (Page 35)
[BATT/SIGNAL]: Shows the strength of the battery and signal. ;
[DATE]: Shows the date.
Default: [XX]