Volpi V-BLACK VITA Manual De Uso página 22

5.6. OPERATIONS TO BE CARRIED OUT AT TERMINATION OF WORK
When finishing work, pour the remaining liquid in a specific container and carefully rinse the internal of the tank and the hose
letting it flow through the lance with clean cold water.
Check that the water used for rinsing has completely come out.
Turn off the pump by turning knob W counterclockwise and check that led Z is off.
After having cleaned the tank, remove, clean and reassemble the filters (Q and P).
Unscrew the nozzle F1 from the lance F-G; disassemble the nozzle and clean the two parts with clean water, paying attention
not to damage or loose the OR.
Clean the handle using a damp cloth without soaking it in water. Unscrew the nut D1; remove the hose from its holder; remove
the hose holder with filter and wash it with clean water; then, reassemble all the parts.
Remove from the tank eventual materials or objects that could damage the sprayer.
Wear clothes and protective devices during these activities.
WARNING: Do not disperse the rinsing water neither the remaining solution in the environment; it is recommended
to pour all these liquids in specific drains, suitable for water purification and drainage.
Turn off the pump by turning knob W counterclockwise and check that led Z is off after every use.
Keep the sprayer out of reach from children, protected from sunrays and cold temperatures and with completely charged
battery.
5.7. CHANGE OF LIQUID IN THE TANK
In case a change of the liquid inside the tank is necessary, follow the instructions given in point 5.6 and after that, the
instructions in point 5.2.
6. MAINTENANCE
6.1. INTRODUCTION
A correct use of the sprayer and a regular maintenance are necessary to keep the sprayer in the best working, efficacy and
safety conditions.
Use exclusively original spare-parts.
6.2. BATTERY RECHARGE
The sprayer powered by a sealed storage battery, rechargeable with the supplied battery charger N.
In order to handle the battery in a safe way it is necessary to follow the below listed instructions:
•
Keep the battery away from high temperatures (ex. flames).
•
Do not open the battery.
WARNING: During the recharge operations, follow safe working procedures and carefully observe the general safety rules.
In order to recharge the battery, follow these instructions:
•
Turn off the pump by turning knob W counterclockwise and check that led Z is off
•
Check that the network voltage corresponds to the indication printed on the battery charger plate N.
•
Open the side door and pull out the battery.
•
Connect the battery charger N to a suitable and electrically protected current-socket.
•
Insert the battery charger plug into the battery slot.
•
To recharge the battery completely, you need 2 hours.
•
At the end of the re-charge it is recommended to disconnect the battery charger from the power network first and then
from the battery;
•
During long periods of inactivity, check that the led Z is off.
DAVIDE E LUIGI VOLPI S.p.A. - Via San Rocco,10 - 46040 CASALROMANO (MN) – ITALY
Adjustable brass nozzle for spraying (Cod. 928)
PRESSURE FLOW RATE
bar Lt / min
5,0 0,60
4,0 0,54
3,0 0,49
2,0 0,44
Sprayable liters for each
battery charge
75
85
90
95
pag. 22 di 80