Publicidad
Idiomas disponibles
Idiomas disponibles
60800985
24/1/07
20:21
INSTALLATION:
Such appliances must be set inside the
kitchen chimney, at a minimum distance of
50 mm. to the side panels, as shown in fig.
1.
For its installation, make two holes of 6 mm.
diametre, being 300 mm. distant. Next,
insert the plastic plug and screws hooks
supplied with the appliance and hand it from
its rear side. Following, mark in the wall the
exact point where the plastic plug should be
placed to fix the extractor (hole situated at
the lower part of the cover).
NOTA: Do not connect the extractor to a
smoke chimney, ventilating or heating
ducting. Before connecting with the tubing,
consult the bylaws concerning air-ducting
and
ask
permission
responsible for the building. Make sure that
the ventilation is the appropiate even when
using simultaneously the extractor together
with other appliances connected to a
source other than electricity.
The extracted air should not be channelled
through the same pipes that are used to
extract the fumes from gas -or other fuel-
operated appliances.
ELECTRICAL CONNECTION:
Before proceeding to the connection, check
the main power tension to be suited to the
characteristics label on the extractor.
On the item wiring connection, there must
be
bipolar
switch
superation between contacts of 3 mm.
APPLIANCE CLASS I: It must be connected
to an efficient ground connection. We
decline any responsability of any damage to
people or things in case of improper use.
If the appliance is connected with a plug,
this must be accessible.
Página 6
to
the
person
with
a
minimum
CLEANNING:
DISCONNECT the electric appliance first to
avoid any harm while this operation.
Firstly, take off the oil tray (1) and remove the
filter (2) by pulling out and downwards the
handel in the front side, to release it from its
fixation to the extractor cover (3).
Then, untight the screw (4) till loosing the
piece (3). Pulling up and towards, the piece
will go out of the fixation device (5),
acceeding to the air ducting. Following,
loosen the nut counter clockwise to take off
the turbine (6). Turbine can be cleaned in the
washing machine. The plastic cover must
be cleaned with detergents trying not to wet
the motor. For the assembly of this
appliance, make the same process but on
the other way round, by FITTING THE
MARK OF THE TURBINE (
surface ot the axle.
IMPORTANT:
When the power supply cord is damaged it
must be replaced by an official dealer.
Keep the cleanning instruc-tions on the
packing for the maintenance.
SAFETY NORM: There is a risk of fire if the
extractor is not kept clean. To clean the
appliance use a cloth dampened with
denatured ethyl alcohol. The cleanning
frecuency varies depending on the intensity
of use, nevertheless, it is recommended to
clean it every 2 or 3 weeks.
To clean the light screen (10) or to replace
lamps, take off the screen by smoothly
pulling towards.
Do not flambé under the canopy.
CATA ELECTRODOMÉSTICOS
RESERVES THE RIGHT TO MAKE ANY
TECHNOLOGICAL IMPROVEMENT OR
MODIFICATION WHATSOVER WITHOUT
PRIOR WARNING.
) with the flat
S.L.
Publicidad
