Imit SILVER TA/RF S Manual De Instrucciones página 17

PAIRING THE ROOM THERMOSTAT AND THE RECEIVER
Primarily press the sync button of receiver for 2 seconds and see blinking green light of
receiver.
While your device is turned off, press and hold the button for 3 seconds.
Press the button until the "Adr" menu appears.
Then turn up the button to right or left way.
If the pairing is successful, the green flashing LED on the receiver will be constant.
Receiver and Room Thermostat have been paired to each other.
ROOM THERMOSTAT TEMPERATURE CALIBRATION
Temperature sensors which are used in Room Thermostats are highly sensitive. You
may need to calibrate your Room Thermostat if you would like to get the same
temperature values with other thermometers in your living space.
While your device is turned off, press and hold the button for 3 seconds.
Press the button until the "CAL" menu appers. In order to see the desired temperature,
set the temperature difference by turning the button to right or left. This value can be
arranged between "-8oC" and "+8oC".
To save the settings and exit, press the "On/Off" button until the device turns off.
Note: Recommended tempreture calibration is "0.0oC".
ROOM THERMOSTAT HEATING / COOLING MODES
Your Room Thermostat has heating and cooling modes. In order to switch easily
between heating and cooling modes:
While your device is turned off, press and hold the button for 3 seconds.
Press the button until the "FUN" menu appears.
You can switch between "HEA" (heating) and "FUN" (cooling) modes by turning the
button to right or left in the "FUN" menu.
To save the settings and exit, press the button until the device turns off.
The settings you have made have been saved. Once you turned on your device, it will
operate with the changed settings.
FACTORY SETTINGS RESET
You can reset your Room Thermostat to its default factory settings. This operation
resets the calibration setting and heating/coling modes to factory setting. To reset your
Room Thermostat to factory setting:
While your device is turned off, press and hold the button for 3 seconds.
Press the button until the "RST" menu appears.
While in the " RST" menu, turn the button to right or left in order to select "YS" option and
press the button.
Your device will be turned off and reset to factory settings.