Mato pneuMATO 55 Lube-Jet Instrucciones De Empleo página 12

7 Tips for fault diagnostics:
Symptom
Pump does not produce
any grease.
The air motor of the pump
is working too slowly
Warning!
During the removal of the screw-nut, only hold in the area (20mm) directly
behind the washer
8 Specifications:
Air pressure pump pneuMATO 55
Size of device
Pressure transfer
Max. delivery pressure at 8 bar compressed air
connection.
Air pressure min./max.
Volume level:
fluid temperature (lower temperatures are
possible, depending on the fluidity of the grease)
Thread
Air connection
Grease outlet
Suction tube diameter
Suction tube length
Weight
Lubricants:
Grease up to the consistency of 2 (NLGI / Class 2 according to DIN 51818) can be used. Pastes
without lubricative properties (with abrasive emery parts) as well as grease or pastes that are
based on silicone oil and thickened with PTFE are not allowed to be used with this device.
9 Disposal
After termination of use the device is to be disposed of in an environmentally
friendly manner in accordance with applicable statutory provisions.
Grease-tainted parts do not belong in the dustbin!
The applicable regulations for the registration, installation and operation of equipment for
handling of substances hazardous to water are to be strictly observed by the operator (such as,
e.g., Federal Water Act, German Ordinance on Exposure to Substances Hazardous to Waters
and Technical Rules and Regulations for Flammable Liquids).
12
/ Benzstr. 16-24 / 63165 Mühlheim a. Main / Tel:+49(0)6108-906-0 / Fax:+49(0)6108-906-120
GmbH & Co. KG
MATO
Possible cause
The container is empty.
The grease supply has been
interrupted.
There is a lack of air pressure.
Suction sieve is dirty.
Suction screen is clogged.
Filter at air inlet is clogged.
Filter in the handle of the gun
nozzle is clogged.
Connection pressure is too low.
Washer
20mm
Suction
Rectification
Check the level of the container.
Vent the pump.
Check supply line.
Clean suction sieve
Clean suction sieve
Clean filter (see picture)
Clean filter
Correct pressure settings
Nut
Air filter
Lube-Jet
10-25 kg 50 kg
1:55
250 bar
3 – 5 bar
ca. 85
5°C bis +50°C
Rp ¼"
R ¼"
40 mm
495 mm 690 mm
4.9 kg 5.6 kg
Operating manual
pneuMATO 55 Lube-Jet
200 kg
dB(A)
885 mm
6.4 kg