Worx WX543 Manual Original página 11

used for comparing one tool with another.
The declared vibration total value and the declared
noise emission value may also be used in a
preliminary assessment of exposure.
WARNING: The vibration and noise
emissions during actual use of the power tool
can differ from the declared value depending on the
ways in which the tool is used especially what kind
of workpiece is processed dependant on the
following examples and other variations on how the
tool is used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well
maintained.
The use of the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any
anti vibration and noise accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration
syndrome if its use is not adequately
managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing
the job. This may significantly reduce the exposure
level over the total working period.
Helping to minimise your vibration and noise
exposure risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate).
If the tool is to be used regularly then invest in anti
vibration and noise accessories.
Plan your work schedule to spread any high
vibration tool use across a number of days.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE
The machine is intended for sawing wood, plastic,
metal and building materials while resting firmly on
the workpiece. It is suitable for straight and curved
cuts. The saw blade recommendations are to be
observed.
Cordless Jigsaw
ASSEMBLY AND OPERATION
ACTION
BEFORE OPERATION
Removing the battery pack
Charging the battery
Installing the battery pack
ASSEMBLY
Blade Installation
NOTE: Ensure the blade is installed
in place. The black line on the blade
needs to be totally inserted into the
tool-free blade holder.
Blade Removal
NOTE: Hold the blade with one
hand when remove the blade.
Vacuum Adapter Installation
Vacuum Adapter Removal
NOTE: Press and hold the projection
on the bottom of the vacuum
adapter before pulling it out of the
machine.
OPERATION
Pendulum Function
Safety On/Off Switch
NOTE: For safety reasons the On/
Off switch of the machine cannot
be locked; it must remain pressed
during the entire operation.
Increasing or reducing the pressure
on the On/Off switch enables
stepless stroke-rate control of the
switched-on machine.
Straight Cut and Curve Cut
Bevel Cut
NOTE: Remove the vacuum adapter
before adjust the base plate.
NOTE: Rotate the base plate to the
desired position according to the
scale. Ensure the blade is engaged
between the blade positioning
wheel .
Plunge Cut
FIGURE
See Fig. A1
See Fig. A2
See Fig. A3
See Fig. B1
See Fig. B2
See Fig. B3
See Fig. B4
11
See Fig. C
See Fig. D
See Fig.
E1, E2
See Fig.
F , G
See Fig. H
EN