Blocks PRO 30 Manual De Mantenimiento página 37

04
Unclog Nuzzel
04.3 Insert needle
4.3.1. Insert the needle 1 to 2 cm into the nozzle so as to peel off the existing filament.
Attention: The next procedures must be carried out with care so that there is no un-
wanted filament breaking.
At this moment there are two possible cases, being they the machine is loaded with fila-
ment or there is no filament inside the machine.
If there is filaments inside the machine, you will have to break the same about 10 cm above
the tire to make the next task.
If there is no filament inside the machine you will have to arrange about 10 cm of filament to
make the next task.
MANUAL DE MANUTENÇÃO
PRO 30 37