Remington WET2 straight slim Manual Del Usuario página 4

ENGLISH
:(7'5< 6(77,1*
This straightener can be used on wet or dry hair.
:(7 02'( 8VH RQ WRZHO GULHG KDLU
When you turn the straightener on, it will automatically be set to wet mode and default to
200°C – The LCD will be blue
Adjust the temperature using the +/- switches to suit your hair.
For best results on wet hair – use straightener on 230°C and be sure to heat up the unit
for 10 minutes so that is reaches its optimum temperature.
NOTE: When straightening wet hair you will hear a hissing sound and the unit will steam.
This a good thing – it's the sound of excess water in your hair evaporating and it is not
harmful to the condition of your hair.
'5< 02'(  8VH RQ GU\ KDLU
When you want to use straightener on dry hair, press the wet/dry button and the LCD will
turn green, WKH
WKH WHPSHUDWXUH \RX DUH FXUUHQWO\ XVLQJ
Adjust the temperature using the +/- switches to suit your hair.
Recommendation –
150°C-200°C – best to use on fine, damaged or fragile hair
200°C-230°C – best to use on thick, wavy or difficult to manage hair
*(1(5$/ ,16758&7,216
Wash and condition your hair as normal.
Towel-dry hair thoroughly, removing all excess water.
Comb carefully through your hair, making sure it is free from snags or tangles.
Plug in your wet2straight™ and switch it on. The LCD display will light up.
Adjust the temperature buttons to suit your preference. When the desired temperature is
reached, the LCD will stop flashing and the unit will beep.
Divide hair into manageable sections and prepare to straighten the lowest sections of your
hair first.
Starting at the base of the neck, place a section of hair between the plates, ensuring that
the vents top of the straightener are directed away from the face/scalp. Remember: the
smaller the sections, better the results.
Close the plates and immediately glide the straightener down the section of hair - gently
moving from roots to tip.
Continue to run the section of hair between the plates until the preferred straightening
and drying is achieved. For thicker hair, you may need to go over sections more than once.
When styling is complete hold the on/off button too turn the unit off, unplug and allow to
cool before storing.
2
090220_REM_IFU_S7902_22L.indd 2
INSTRUCTIONS FOR USE
DQG \RX ZLOO VHH D FORXG LFRQ DSSHDU RQ WKH GLVSOD\
FORXG LFRQ ZLOO GLVDSSHDU DQG WKH WHPSHUDWXUH ZLOO GURS ƒ& ORZHU WKDQ
16:26:00|30.04.09 Guido Krölls