Remington WET2 straight slim Manual Del Usuario página 5

ENGLISH
BETTER RESULTS
Results with wet2straight™ are better than with a normal straightener because the cuticle
is not being roughened up by the hairdryer. Instead, it lies flat from wet to dry, leaving hair
shiny, smooth and protected.
DO'S
Do ensure vent holes are directed away from face, head or hair.
Do make sure hands are dry before using wet2straight™ and don't hold them over the
vent holes.
Do use wet2straight™ on dry hair if required.
Do use wet2straight™ on wet hair - just ensure hair is towel-dried before use.
DON'TS
Don't allow dripping wet hair to come in contact with this straightener.
Don't use a normal 'dry' straightener on wet hair.
Don't be alarmed when you hear a hissing sound and see steam - it's the sound of the
excess water. When wet2straight's plates come in contact with towel-dried hair, this is
perfectly normal.
Due to the extreme heat capabilities of this styler, extra care should be taken when using.
Before use, make sure hair is towel-dry and tangle-free. This straightener can also be used
on dry hair.
The unit has adjustable +/- temperature buttons. Choose lower temperature settings for
fragile, bleached or dry/damaged hair. Choose higher temperature settings for thick or
difficult to straighten hair.
It is very important that the holes in the plates are held away from the face and hair, as the
water from the hair will escape through the holes as steam, which is very hot.
For shorter hair, place a plastic comb between scalp and styler to avoid touching scalp.
Do not leave switched on for more than 30 minutes.
Before use, make sure hair is clean, dry and tangle-free.
While heating, during use and cooling, place on flat, smooth, heat-resistant surface.
Only hold unit at the end of the handle. Ensure the heat protection pad is used in all cases.
Do not style too close to scalp, face, ears, neck and skin.
Please note regular use of styling products may deteriorate the coating. Wipe clean
regularly to maintain performance.
Do not use an abrasive cleaning fluid to clean the plates, as damage will occur. Use a soft
damp cloth on the unit while unplugged.
Do not scratch the surface of the plates as this will deteriorate the effectiveness of the
coating.
For extra protection and best results, section hair prior to straightening and spray with
heat protection spray. Always straighten the lower layers first.
090220_REM_IFU_S7902_22L.indd 3
IMPORTANT INSTRUCTIONS
3
16:26:00|30.04.09 Guido Krölls