Care And Cleaning - Spa Pro SP-08 Manual Del Usuario

9. Press START button to begin heating stones. Display will show actual
temperature of reservoir water and the time remaining. Depending
on the amount of stones, temperature setting and amount of water
used, it usually takes 15-30 minutes to heat to desired temperature.
10. Press STOP to pause timer and make adjustments to the time or
temperature. Press START to resume.
 CAUTION:
• Use a thermometer to measure water temperature in the reservoir
to ensure that stones are at a proper therapeutic temperature.
Consult a professional therapist for correct stone temperatures if you
are not sure.
11. Place cover on reservoir and allow stones to heat.
12. When temperature is reached, carefully remove the first stone from
the reservoir, using tongs or slotted wooden spoon and place it on a
towel. Test the temperature of the stone by touching it with your
finger, then holding in your hand. The temperature should feel warm
to the touch, but not uncomfortable.
13. Proceed with the massage. The heater will keep stones at a
consistent temperature for as long as the time set.
14. When the therapy session is finished, press POWER button and
remove cord from outlet. Always unplug appliance before cleaning
and when not in use.
15. Allow water and stones to cool and follow cleaning directions in the
"Care and Cleaning" section.
1. It is important that the stones and heater be cleaned and sanitized
properly between each client or after each use.
2. Remove cord from electrical outlet and allow appliance to cool.
3. Remove stones and towel from reservoir. Using handles, move base
over a sink and remove excess water into drain. Pour from the corner
of the reservoir and pour quickly to prevent excess water dripping
down the side of the base. Wipe dry any spills.
4. Clean reservoir by wiping with a soft cloth with warm soapy water,
then wipe clean with water on a soft cloth and wipe dry.
5. Clean cover by washing in soapy water and dry with a soft towel. The
cover is dishwasher safe, place on the upper rack.
6. Wipe outside of base with a damp cloth. Never immerse base in
water.
7. Rinse the stones in warm water with a small amount of mild
detergent added. Scrub stones to remove dirt from the porous surface
and allow to dry.

Care and Cleaning

5