Initial Setup - DeWalt DS505 Manual De Instrucciones

INITIAL SETUP

Mounting
DS505 EXTENDED RUN-TIME ADAPTER
1. Open the DS505 door.
2. Open the DS500 charging port door to access the charging port
as shown.
D-SIZE
ALKALINE
BATTERIES
3. Insert four D-size alkaline batteries (not provided).
4. Insert the DS500 MOBILELOCK
it has complete contact with the DS505 connector. The
TM
MOBILELOCK unit will beep when the batteries and the
unit are properly inserted to indicate power is provided to the
MOBILELOCK TM unit.
A
A
A
A
TM unit as shown. Be sure
NOTE: For optimum run-time, do not use rechargeable
batteries. Use only high-quality alkaline batteries. The
DS500 may be fully charged before inserting the unit into
the DS505 for additional run time.
5. Attach the DS505 to your asset by inserting four #8 screws
(not provided.) in the mounting holes (A) as shown.
6. Close door.
DS510 INDOOR MOTION DETECTOR
IMPORTANT: Before inserting battery,
make contact with the gold (+) and the
(+) battery terminal at the same time
with a metal object to reset indoor
motion detector circuitry.
1. Insert the enclosed CR-123 lithium ion battery into the battery
compartment on the back of the DS510. Always insert batteries
correctly with regard to polarity (+ and -) marked on the battery
and the equipment.
2. The DS510 indoor motion detector can be mounted flat against
a wall or in a corner using two # 8 screws.
3. Open the DS500 charging port door to
access the charging port.
4. Insert the DS500 MOBILELOCK
shown. Be sure it has complete contact with
the DS510 connector.
Recommended locations
• Recommended for use in enclosed areas,
offices, climate controlled storage, and
monitoring interior spaces.
• The DS510 functions best when areas being protected are
bounded by solid barriers. Walls and floors provide good
backdrops for detecting changes in infrared energy.
3
3V
CR123
TM unit as