Trust PREMIUM ZCM-1800 Manual Del Usuario página 7

10. Optional: Also connect with Zigbee remote
control
Go to www.trust.com/faq for more information on how the
switch can be connected with a zigbee remote control.
11. Install module
First check whether the lighting switches properly.
Place the switch in the ceiling box. Reinstall the lamp.
Make sure that you can always reach the built-in switch,
for example to reset it or to reconnect it.
Activate connection mode
If the ZCM-1800 is not connected to an Smart Bridge or
ICS-2000, you can enter the connection mode by pressing
the join button shortly on the module.
The LED will flash slowly for 60s to indicate it is in connect
mode
Reset ZCM-1800
Warning: This step removes the module from the Smart
Bridge or ICS-2000 or the ZYCT-202. To reset the switch,
press the join button for 6 seconds. The LED will flash
quickly. Shortly press the button again. The connected
lamp will go ON-OFF-ON-OFF to confirm the reset and then
enter connect mode.
ZCM-1800 BUILD-IN SWITCH
EN
7