Chicco goody pro Manual De Instrucciones página 15

• Kaily car seat
• Kiros i-Size/Kiros Evo i-Size car seat with Fast In fastening
All car seats for use on the stroller require the special adaptors
sold separately.
WARNING: FOR THE ASSEMBLY AND/OR USE OF THE
ITEMS LISTED ABOVE, REFER TO THE RELEVANT MANU-
ALS.
SOFT CARRYCOT MOUNTING AND REMOVAL FROM THE
STROLLER
The Goody PRO stroller is compatible with the Chicco Soft Car-
rycot.
To attach the carrycot to the stroller, remove the bumper bar,
completely lower the backrest and place the legrest in the hori-
zontal position.
17. Turn the rod under the carrycot base until it is completely
open (Fig. 17-17A); hold the handles in the transport posi-
tion and place the carrycot on the stroller with the foot area
facing the handle of the stroller (Fig. 17B).
18. Attach the carrycot to the stroller's frame using the appro-
priate straps. The carrycot has two straps with a buckle on
each side. Wrap the straps around the stroller frame in the
positions shown in Figure 18, fasten the buckles (Fig. 18A),
pull the straps to ensure a secure attachment (Fig. 18B) and
close the second safety lock (Fig. 18C). Repeat the opera-
tions on the opposite side as well.
WARNING: Before use, make sure that the carrycot is properly
attached by pulling it upwards.
To remove the carrycot from the stroller, release the buckles
and remove it from the seat.
WARNING: The fastening and releasing operations can be
carried out with your child inside the carrycot; however, these
operations may be more difficult to execute due to the child's
weight. Pay attention when carrying out the aforementioned
operations.
REDUCER CUSHION
19. The Goody PRO stroller is equipped with a reducer cushion.
Follow the assembly instructions below. Open the buttons
for the hood located on the rear of the backrest and attach
the buttons for the reducer cushion in their place (Fig. 19-
19A). The buttons for the hood can then be fastened to the
buttons for the reducer cushion (Fig.19B). Have the safety
harnesses pass through the slots on the reducer cushion
(Fig. 19C) and, after placing the baby in the seat, fasten the
safety harnesses to the buckle (Fig. 19D), as described in the
paragraph on "Using the safety harnesses".
WARNING: The reducer cushion must always be used with the
buttons fastened to the backrest.
WARNING: The reducer cushion must always be used with the
safety harnesses fastened.
WARNING: When carrying children up to 6 months of age
with the reducer cushion installed, the shoulder straps must be
passed through the two adjuster slots and the waist strap must
be passed through the vertical slots.
WARNING: ALWAYS make sure that the reducer cushion does
not obstruct the baby's airways.
WARRANTY
The product is guaranteed against any lack of conformity under
normal use as specified in the instructions. The warranty does
not, therefore, apply to damage caused by improper use, wear
or accidents. For the duration of the warranty against lack of
conformity, see the specific provisions of applicable national
laws in the country of purchase, where present.
15