DELICE
1 TECHNICAL CHARACTERISTICS
Transparent removable bowls
Capacity of each bowl, approx.
Dimensions:
width
depth
height
Net weight, approx.
Gross weight, approx.
Adjustable thermostats
Noise level lower than 70 dB (A)
IMPORTANT
Electric specifications: read the informa-
tion on the data plate of each single
dispenser, situated on the underside. The
serial number of the units is preceded by #
The manufacturer reserves the right to make
changes without any prior notification.
2 INTRODUCTION
Read this instruction manual carefully to know the
specifications of the dispenser. As all mechanical
products, this unit requires cleaning and mainte-
nance. Its working order can be compromised by
possible errors made by the operator during di-
sassembly and cleaning. For this reason it is im-
portant that the staff in charge of the dispenser is
qualified to carry out the day to day operations,
which are dismantling, cleaning, sterilisation and
reassembly.
3 INSTALLATION
1
Remove the dispenser from the packaging.
(This should be kept for any future requirement)
2
Check the dispenser has not been damaged
during transport. The forwarding agent must be
notified immediately of any claim.
3
Install the dispenser on a counter top that will
support its weight, even with a full load.
4
Before connecting the dispenser electrically
check that the voltage (in the network) is as
shown on the data plate. Plug the unit into a
grounded, protected single phase electrical sup-
ply according to the applicable electrical codes
Delice
and the specifications of your machine. If the
dispenser has no plug, conforming to the regula-
n
1
tions in your Country, to the cable, supplied with
an earthing pin or earthing contact and suitable
l
5
to currents of at least 10A 250V (for areas with
tension of 220V-230V 50-60Hz) and 20A 250V
(for areas with tension of 100-115V 50-60Hz). If
cm
24
you want to make a fixed connection to the
network, connect the cord to a bipolar wall bre-
cm
32
aker with a contact gap of at least 3mm. not use
cm
49
extension cords to connect the unit electrically.
kg
7
kg
8
n
2
Ensure that the unit is grounded correctly;
if not it may cause electric shock to per-
sons or damage the dispenser.
5
The dispenser does not leave the factory
presanitized and sanitized. Prior to use it must be
disassembled, cleaned and sanitized according
to the instructions in chapter 5.3 CLEANING.
4 TO OPERATE SAFELY
1
Read the instruction booklet before using the
dispenser.
2
Use the dispenser only if it is grounded cor-
rectly.
3
Do not use extension cords to connect the
dispenser electrically.
4
Do not operate the dispenser if it is not clo-
sed and blocked with screws.
5
Do not place fingers or objects in the cooling
fissures and faucet outlet panels louvers.
6
Do not open the dispenser for cleaning or
maintenance without ensuring it has been
disconnected from the electricity.
7
Do not remove the container when the unit is
in operation.
Do not remove the container until the hot
plate is cold.
Do not remove the container from the
dispenser when it contains hot products.
8
ATTENTION
ATTENTION
ATTENTION