Publicidad
Idiomas disponibles
Idiomas disponibles
SYMBOLS
To reduce the risk of injury, user must
read instruction manual
Double insulation
Warning
Wear ear protection
Wear eye protection
Wear dust mask
18
OPERATION
INSTRUTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE
The machine is intended for lengthways and crossways
cutting of wood with straight cutting lines as well as bevel
angles to 45° while resting firmly on the work piece.
1. FITTING/CHANGING A SAW BLADE (SEE
FIG. A1, A2, A3)
Press the spindle lock button and use the hex key to loosen
and remove the blade bolt (11). Remove the outer flange
(10). Rotate the lower blade guard clockwise by pushing
the guard lever to take out the old blade (12). Fit a replaced
blade. Ensure that the blade bore is located on the inner
flange (a) and the blade direction arrow points in the same
direction as the fixed guard arrow. Place the outer flange,
the blade bolt onto the blade bore. Press the spindle lock
again and use the hex key to tighten the bolt with 1/4
turn more than finger tight. Check if the blade is securely
clamped.
Warning: Blade teeth are very sharp. For
best cutting results ensure you use a saw blade
suited to the material and cut quality you need.
2. DEPTH OF CUT ADJUSTMENT (SEE FIG. B)
Lift the depth of cut lock lever and raise the saw body away
from the base plate. Set the depth of cut with the scale and
push the lever down to lock. Always add 3mm to your depth
of cut so that the blade can cut through the material.
3. BASE PLATE ANGLE ADJUSTMENT (SEE
FIG. C1, C2)
Turn the base plate bevel lock in anti-clockwise direction
to loosen the angle scale. Tilt the base plate away from the
machine until the required cutting angle is adjusted on the
angle scale. Tighten the bevel lock by turning it in clockwise
direction. Do not use the depth of cut scale when making
bevel cuts due to possible inaccuracy.
4. DUST EXTRACTION OUTLET (SEE FIG. D)
Fasten the vacuum adapter (14) onto the dust extraction
outlet until it latches. Additionally fasten the vacuum adapter
(14) to the fixed guard with the two screws. Directly connect
a suitable vacuum hose to the adapter.
Clean the vacuum adapter regularly to
ensure optimum dust extraction. The
vacuum cleaner must be suitable for the
material to be worked.
EN
Publicidad
